Blog

1 Unlike other cement products, it is designed to be applied in very thin coats (no more than 1/2 inch thick), and its additives provide good adhesion to an existing slab. Concrete resurfacer is a very strong product, rated for compressive strength of about 4,500 psi.Nov 27, 2021

That begs the question, “does concrete resurfacing last?” The short answer is, “yes.” If there are no issues with the underlying foundation the resurfacing agent pours onto, then the new material will last. It bonds to the foundation, creates a seal, and leaves you with a brand-new concrete driveway.Nov 13, 2019

In most cases, a poor concrete job cannot be saved; the slab should be removed and a new one poured in its place. If the visible finishing was done poorly then you can assume there are other hidden problems that will soon appear.

You can restain them for a different color finish once the sealer wears off or is removed but you need to think of these like a honed finished stone. A polished finish would be dangerously slippery / even what you have is probably slippery when wet.

• Remove baseboards
• Tape off the room with plastic sheets
• Sand the floor completely
• Allow the floor to dry. Spray on the acid stain with a backpack sprayer. You can apply multiple coats waiting 2-3 hours in between.
• Rinse the floor thoroughly
• When dry,add acrylic-based sealer (which can also be tinted with acrylic paint)
• Wax the floors. There can be a lot of confusion about how to stain interior concrete floors! Should I use acid stain or water-based stain?

• Instructions: Sweep your floors thoroughly to remove all loose debris. Run your dust mop over the floor to pick up any dust and fine particles. Fill bucket with about 1 gallon of warm water and a small amount of mild cleaner or dish soap. Dip wet mop in cleaning solution and wring thoroughly.

• Two of the best options for waterproof flooring for basements are epoxy paint and sealed concrete. Not only are both affordable, but they are durable and allow for adequate waterproofing. Epoxy paint dries thick and hard, providing the necessary durability that goes hand-in-hand with maintaining a basement floor.

• Installing hardwood floors over a concrete slab beautifies the concrete while adding value to the home. If the concrete is properly prepared, you can install a hardwood floor directly onto the concrete without a subfloor. Choose a hardwood that complements your decor, and combine it with tile or carpet as desired on your concrete slab. Preparation.

How can I re-stain my concrete floors? To start, you’ll need to have the existing surface mechanically ground down, both to prime the concrete to accept a new stain and to remove as much of the offending color as possible.

If you’re remodeling an existing facility or renovating an older building, chances are you have a concrete floor in need of refinishing. Perhaps it’s badly stained or cracked, or maybe it’s just lackluster and needs an upgrade to fit into your company’s updated look.

Concrete resurfacing can repair minor damage and restore a floor, but it will not fix deep cracks or heaving. Resurfacing will simply help make it more pleasant in appearance. Here we will explore some resurfacing ideas and options, as well as some tips on how to do it effectively.

Using stencils allows you to add attractive, yet economical, color and texture to indoor concrete surfaces. With hundreds of patterns available, and the ability to create custom stencils, the possibilities are endless. 4. Polishing The ultimate no-wax floor, polished concrete offers great value and is a superior, low-maintenance flooring option.

Sometimes a concrete slab is just too unstable or too badly damaged to make resurfacing possible. But when the problem is just superficial cracking, discoloring, or minor chipping or spalling, resurfacing is a very good option.27 nov. 2021

Eventually one or both of these thin slabs will crack. In addition to the bonding agent, resurfacing compounds also include additives that make it extremely strong, even in thin layers.