Blog

Some splash guards sit inside the mouth of the garbage disposal opening, and can easily be removed and cleaned.

Baking Soda and White Vinegar: One of the greenest ways of freshening your garbage disposal is to pour ¼ cup of baking soda in it, then add a cup of white vinegar. The bubbling reaction naturally kills bacteria and germs that cause odor. Let it bubble for a few minutes and then run some water through the disposal.May 27, 2016

To clean the garbage disposal drain: Pour a 1/2 cup of baking soda into the drain, add a cup of hot distilled white vinegar (just heat it in the microwave), then watch it foam, says Reichert. “Let it sit for a few minutes, then pour a quart of boiling water down the disposal to flush everything down the drain.Apr 7, 2021

A garbage disposal's rubber splashguard, located inside the sink flange, prevents water and food from splashing up when the disposal is in use. The guard, or cover, may deteriorate due to normal wear and tear, and can be replaced.

Garbage Disposal Splash Guard / Sink Baffle, Fits Insinkerator Disposals and Most Universal 3 1/2 inch Sinks.

You can use bleach if it's a mild product and the water is running. Trying pouring just a little bit of bleach down the disposal as cold water runs, and you'll find it erases the scent. The bleach also goes to work on dislodging any food particles that may be stuck in your pipes.Mar 28, 2018

• After cleaning each section of the splash guard, rinse it thoroughly (both sides) with hot water for maximum efficiency. It is important to keep rinsing the brush during this process to keep the slime under control. What is a Garbage Disposal Rubber Flange? What is a Garbage Disposal Rubber Flange?

• This rubber flange can accumulate a lot of debris over time that can produce an unwanted smell. As it is difficult to clean from outside, a lot of people are unable to maintain it. Likewise, it does tend to wear out with time. Therefore, replacing a garbage disposal splash guard is important.

• Now, use the toothbrush and the soapy water to scrub the underside and top of the splash guard flaps. For this purpose, you will need to lift each section of the rubber flange one-by-one.