Blog

A drainage plate is designed to catch water that flows out the bottom of your pot. Without a bottom plate, water can flow through the soil in your container and out the bottom drainage holes, leaking onto your planter shelf, table, flooring, patio or deck.

In general, it's not necessary to put rocks in the bottom of plant pots. One rock to cover the drainage hole is enough – just enough so that the soil doesn't leach out of the bottom but water can flow freely through the pot. Putting rocks in plant pots doesn't aid drainage or improve air circulation.Sep 16, 2021

Solution: Buy a bag of foam packing peanuts instead (available at office supply stores). Fill the pot one-third to one-half full of peanuts, cover with landscape fabric and then add soil. This cuts the weight and saves money, since peanuts cost less than good potting soil.

Stakes and trellises support plants both in containers and outdoors. Drive the stake at least 3 inches into the ground, and more for taller plants. Tie the plant to the trellis or stake with twist ties, twine, rope or plant ties.

You can use a trellis, fence or even a clothesline for this purpose. Place the pot near the support system and tie the stem of the plant to the support. If you're concerned about damaging the plant, consider placing a wooden stake in the pot. Then tie the stake to the support, advises North Carolina State University.

Simply undo a carton until it is completely flat. Slide it under the pot (get a helper to lift very briefly) and ensure that the pot is sitting in the middle. Shift the pot by pulling along the cardboard until the pot reaches its new destination.

Water your potted plants before moving day, but just add enough to keep them from drying out during transport. Pack the pots snugly in open-top boxes – use newspaper or bubble wrap to keep them steady during the ride. Once you arrive, put your potted outdoor plants in their new garden homes.

If you're planting in large containers, you can use a layer of plastic bottles at the bottom to help fill them up. The bottles should be empty, but not crushed, and have the caps on them. You can use water bottles or half-gallon jugs.

To stake using single plant stakes, push a stake into the ground beside the plant, making sure the stake is not taller than the plant itself. Tie the plant to the stake about two-thirds of the way up the stem using string, twine or hook-and-loop tape made especially for staking.