Blog

In a situation where the motor doesn't work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. ... Start by checking the blower fuse and HVAC controller fuse.Jan 28, 2017

More often than not, electric heaters blow cold air when its filters are clogged, and that's why it's the first thing you should check. Start by turning your heater off and inspecting the filters. If the filters are caked with dust, then it's likely the culprit behind your heater's malfunction.

Most newer furnaces, including gas furnaces, do have a fuse. ... Every furnace requires an electrical connection in order to run. The blower motors and the control circuits both run off of electricity rather than gas. The fuses on the furnace tend to be relatively low voltage, ranging from three to five amps.May 27, 2020

All furnaces are equipped with a reset button. They are generally red or yellow and are located inside the blower compartment. The reset button is a safety feature that will shut down the furnace when a problem is detected, often a hot or overheating furnace, before it trips the circuit breaker.Nov 17, 2020

Replacing a blower motor costs $450 on average with a typical range of $250 to $800. With a warranty, you might pay as little as $150 for labor alone. For high-end models, like those with large motors or access issues, you might pay as much as $2,000.

Many vehicles have two fuses for the blower motor, one in the interior fuse block and the other under the hood. The blower motor is usually under the dashboard on the passenger side.

Locate the reset button on the heater and press it to reset the heating system. It is usually located inside the blower area on the side of the blower motor. Beware as it may be hot. If the button appears, press it down.Oct 7, 2021

So, if your furnace keeps turning off and on too quickly, your thermostat might be malfunctioning or broken. There are several things that could be causing your thermostat to not work properly. The wiring could be old and need replacing, it might need new batteries, or it could be the location of your thermostat.

If your furnace pilot light keeps going out, it's likely you have a broken thermocouple in your gas furnace. The thermocouple is a rod that comes into physical contact with the flame in your system. ... When this component is not able to detect the flame, it will close the gas valve to prevent a gas leak in your home.Apr 27, 2021